3Com 3CRWX120695A, 3CRWX440095A manual Set radio-profile auto-tune channel-config

set radio-profile auto-tune channel-config 281

Examples — The following command configures the 802.11b/g radios in radio profile rp1 to allow associations from 802.11g clients only:

WX4400# set radio-profile rp1 11g-only enable success: change accepted.

See Also

„display {ap dap} config on page 237

„display radio-profileon page 257

„set port type ap on page 83

„set radio-profile mode on page 291

set radio-profile auto-tune channel-config

Disables or reenables dynamic channel tuning (RF Auto-Tuning) for the MAP radios in a radio profile.

Syntax — set radio-profile name auto-tune channel-config {enable disable}

„name — Radio profile name.

„enable — Configures radios to dynamically select their channels when the radios are started.

„disable — Configures radios to use their statically assigned channels, or the default channels if unassigned, when the radios are started.

Defaults — Dynamic channel assignment is enabled by default.

Access — Enabled.

History —Introduced in MSS Version 3.0.

Usage — If you disable RF Auto-Tuning for channels, MSS does not dynamically set the channels when radios are first enabled and also does not tune the channels during operation.

If RF Auto-Tuning for channels is enabled, MSS does not allow you to manually change channels.

Examples — The following command disables dynamic channel tuning for radios in the rp2 radio profile:

WX4400# set radio-profile rp2 auto-tune channel-config disable