set igmp oqi 363

set igmp oqi

Changes the IGMP other-querier-present interval timer on one VLAN or

 

all VLANs on a WX.

Syntax — set igmp oqi seconds [vlan vlan-id]

„oqi seconds — Number of seconds that the WX waits for a general query to arrive before electing itself the querier. You can specify a value from 1 through 65,535.

„vlan vlan-id— VLAN name or number. If you do not specify a VLAN, the timer change applies to all VLANs.

Defaults — The default other-querier-present interval is 255 seconds (4.25 minutes).

Access — Enabled.

History — Introduced in MSS Version 3.0.

Usage — A WX cannot become the querier unless the pseudo-querier feature is enabled on the WX switch. When the feature is enabled, the WX becomes the querier for a subnet so long as the WX does not receive a query message from a router with a lower IP address than the IP address of the WX in that subnet. To enable the pseudo-querier feature, use set igmp querier.

Examples — The following command changes the other-querier-present interval on VLAN orange to 200 seconds:

WX1200# set igmp oqi 200 vlan orange success: change accepted.

See Also

„set igmp lmqi on page 360

„set igmp qi on page 364

„set igmp qri on page 365

„set igmp querier on page 366

„set igmp mrouter on page 360

„set igmp rv on page 368

Page 363
Image 363
3Com 3CRWX120695A, 3CRWX440095A manual Set igmp oqi, All VLANs on a WX, Syntax set igmp oqi seconds vlan vlan-id