3Com 3CRWX120695A, 3CRWX440095A manual Single logical link, With no spaces

		set port-group 77
	See Also
	„ reset port on page 73
set port-group	Configures a load-sharing port group. All ports in the group function as a
	single logical link.
	Syntax — set port-group name group-nameport-list
	mode {on off}
	„	name group-name— Alphanumeric string of up to 255 characters,
		with no spaces.
	„ port-list— List of physical ports. All the ports you specify are
		configured together as a single logical link.
	„	mode {on off} — State of the group. Use on to enable the group

or off to disable the group. The group is enabled by default. Defaults — Once configured, a group is enabled by default. Access — Enabled.

History — Introduced in MSS Version 3.0.

Usage — You can configure up to 8 ports in a port group, in any combination of ports. The port numbers do not need to be contiguous and you can use 10/100 Ethernet ports and gigabit Ethernet ports in the same port group.

After you add a port to a port group, you cannot configure port parameters on the individual port. Instead, change port parameters on the entire group. Specify the group name instead of an individual port name or number in port configuration commands.

To add or remove ports in a group that is already configured, change the mode to off, add or remove the ports, then change the mode to on.

Examples — The following command configures a port group named server1 containing ports 1 through 5, and enables the link:

WX1200# set port-group name server1 1-5 mode on success: change accepted.