3Com 3CRWX440095A Clear snmp trap, Receiver, See Also „ clear ntp server on „ display ntp on

114CHAPTER 6: IP SERVICES COMMANDS

Examples — To reset the NTP interval to the default value, type the following command:

WX4400# clear ntp update-interval success: change accepted.

See Also

„clear ntp server on page 113

„display ntp on page 126

„set ntp on page 148

„set ntp server on page 148

„set ntp update-intervalon page 149

clear snmp trap	Clears a single entry from the Simple Network Management Protocol
receiver	(SNMP) trap receiver table.

Syntax — clear snmp trap receiver ip-addr

„ip-addr— IP address of the trap receiver, in dotted decimal notation.

Defaults — None.

Access — Enabled.

History — Introduced in MSS Version 3.0.

Examples — To delete the trap receiver at IP address 192.168.0.1, type the following command:

WX4400# clear snmp trap receiver 192.168.0.1 success: change accepted.

See Also

„set ip snmp server on page 142

„set snmp community on page 150

„set snmp trap on page 151

„set snmp trap receiver on page 153