3Com 3CRWX120695A, 3CRWX440095A manual „ Logging state enabled or disabled

set log 505

„Logging state (enabled or disabled)

To override the session defaults for an individual session, type the set log command from within the session and use the current option.

„trace — Sets log parameters for trace files.

„severity severity-level— Logs events at a severity level greater than or equal to the level specified. Specify one of the following:

„emergency — The WX switch is unusable.

„alert — Action must be taken immediately.

„critical — You must resolve the critical conditions. If the conditions are not resolved, the WX can reboot or shut down.

„error — The WX is missing data or is unable to form a connection.

„warning — A possible problem exists.

„notice — Events that potentially can cause system problems have occurred. These are logged for diagnostic purposes. No action is required.

„info — Informational messages only. No problem exists.

„debug — Output from debugging.

„local-facilityfacility-level— For messages sent to a syslog server, maps all messages of the severity you specify to one of the standard local log facilities defined in RFC 3164. You can specify one of the following values:

„0 — maps all messages to local0.

„1 — maps all messages to local1.

„2 — maps all messages to local2.

„3 — maps all messages to local3.

„4 — maps all messages to local4.

„5 — maps all messages to local5.

„6 — maps all messages to local6.

„7 — maps all messages to local7.

If you do not specify a local facility, MSS sends the messages with their default MSS facilities. For example, AAA messages are sent with facility 4 and boot messages are sent with facility 20 by default.

„enable — Enables messages to the specified target.