3Com 3CRWX120695A Display ip route, Shows the IP route table, Syntax display ip route destination

display ip route 123

display ip route Shows the IP route table.

Syntax — display ip route [destination]

„destination — Route destination IP address, in dotted decimal notation.

Defaults — None.

Access — All.

History —Introduced in MSS Version 3.0.

Usage — When you add an IP interface to a VLAN that is up, MSS adds direct and local routes for the interface to the route table. If the VLAN is down, MSS does not add the routes. If you add an interface to a VLAN but the routes for that interface do not appear in the route table, use the display vlan config command to check the VLAN state.

If you add a static route and the route’s state is shown as Down, use the display interface command to verify that the route has an IP interface in the gateway router’s subnet. MSS cannot resolve a static route unless one of the WX switch’s VLANs has an interface in the gateway router’s subnet. If the WX switch has such an interface but the static route is still down, use the display vlan config command to check the state of the VLAN’s ports.

Examples — The following command shows all routes in a WX switch’s

IP route table:

WX4400# display ip route
Router table for	IPv4		Metric	NH-Type	Gateway	VLAN:Interface
Destination/Mask		Proto
__________________		_______ ______		_______	_______________	_______________
0.0.0.0/	0	Static	1	Router	10.0.1.17	Down
0.0.0.0/	0	Static	2	Router	10.0.2.17	vlan:2:ip
10.0.2.1/24		IP	0	Direct		vlan:2:ip
10.0.2.1/32		IP	0	Direct		vlan:2:ip:10.0.1.1/24
10.0.2.255/32		IP	0	Direct		vlan:2:ip:10.0.1.1/24
224.0.0.0/	4	IP	0	Local		MULTICAST

Table 31 describes the fields in this display.