3Com 3CRWX440095A, 3CRWX120695A manual Output of display ip route, FieldDescription

124CHAPTER 6: IP SERVICES COMMANDS

Table 31 Output of display ip route

FieldDescription

Destination/Mask IP address and subnet mask of the route destination.

	The 244.0.0.0 route is automatically added by MSS and
	supports the IGMP snooping feature.
Proto	Protocol that added the route to the IP route table. The protocol
	can be one of the following:
	„ IP — MSS added the route.
	„ Static — An administrator added the route.
Metric	Cost for using the route.
NH-Type	Next-hop type:
	„ Local — Route is for a local interface. MSS adds the route
	when you configure an IP address on the WX switch.
	„ Direct — Route is for a locally attached subnet. MSS adds
	the route when you add an interface in the same subnet to
	the WX switch.
	„ Router — Route is for a remote destination. A WX switch
	forwards traffic for the destination to the gateway router.
Gateway	Next-hop router for reaching the route destination.
	This field applies only to static routes.
VLAN:Interface	Destination VLAN, protocol type, and IP address of the route.
	Because direct routes are for local interfaces, a destination IP
	address is not listed.
	The destination for the IP multicast route is MULTICAST.
	For static routes, the value Down means the WX switch does not
	have an interface to the destination’s next-hop router. To
	provide an interface, configure an IP interface that is in the same
	IP subnet as the next-hop router. The IP interface must be on a
	VLAN containing the port that is attached to the gateway
	router.

See Also

„clear ip route on page 111

„display interface on page 118

„display vlan config on page 100

„set interface on page 135

„set ip route on page 140