3Com 3CRWX440095A, 3CRWX120695A manual Syntax set ap port-listdap dap-numblink enable disable

266CHAPTER 9: MANAGED ACCESS POINT COMMANDS

set {ap dap} blink Enables or disables LED blink mode on a MAP access point to make it easy to identify.

When blink mode is enabled on an AP2750, the 11a LED blinks on and off.

When blink mode is enabled on an AP7250, the Radio LED flashes red and the Power LED flashes green/orange. The Ethernet LED does not change.

When blink mode is enabled on an AP8250, the Radio LED flashes red and the Power LED flashes green/orange. The Ethernet LED does not change.

When blink mode is enabled on an AP8750, both Radio LEDs flash red and the Power LED flashes green/orange. The Ethernet LED does not change.

When blink mode is enabled on other models (MP-xxx), the health and radio LEDs alternately blink green and amber. By default, blink mode is disabled.

Syntax — set {ap port-listdap dap-num}blink {enable disable}

„ap port-list— List of ports connected to the MAP access points on which to turn blink mode on or off.

„dap dap-num— Number of a Distributed MAP on which to turn blink mode on or off.

„enable — Enables blink mode.

„disable — Disables blink mode.

Defaults — LED blink mode is disabled by default.

Access — Enabled.

History —Introduced in MSS Version 3.0.

Usage — Changing the LED blink mode does not alter operation of the

MAP access point. Only the behavior of the LEDs is affected.