set radio-profile auto-tune channel-interval 283

set radio-profile auto-tune channel-interval

Sets the interval at which RF Auto-Tuning decides whether to change the channels on radios in a radio profile. At the end of each interval, MSS processes the results of the RF scans performed during the previous interval, and changes radio channels if needed.

Syntax set radio-profile name auto-tune channel-interval

seconds

„name — Radio profile name.

„seconds — Number of seconds RF Auto-Tuning waits before changing radio channels to adjust to RF changes, if needed. You can specify from 0 to 65535 seconds.

Defaults — The default channel interval is 3600 seconds (one hour).

Access — Enabled.

History —Introduced in MSS Version 3.0.

Usage — 3Com recommends that you use an interval of at least 300 seconds (5 minutes).

RF Auto-Tuning can change a radio’s channel before the channel interval expires in response to RF anomalies. Even in this case, channel changes cannot occur more frequently than the channel holddown interval.

If you set the interval to 0, RF Auto-Tuning does not reevaluate the channel at regular intervals. However, RF Auto-Tuning can still change the channel in response to RF anomalies.

Examples — The following command sets the channel interval for radios in radio profile rp2 to 2700 seconds (45 minutes):

WX4400# set radio-profile rp2 auto-tune channel-interval 2700 success: change accepted.

See Also

„set radio-profileauto-tunechannel-configon page 281

„set radio-profileauto-tunechannel-holddownon page 282

Page 283
Image 283
3Com 3CRWX120695A Set radio-profile auto-tune channel-interval, Syntax set radio-profile name auto-tune channel-interval