3Com 3CRWX440095A, 3CRWX120695A Set ap dap radio tx-power, Sets an MAP radio’s transmit power

278CHAPTER 9: MANAGED ACCESS POINT COMMANDS

„set radio-profile mode on page 291

set {ap dap} radio tx-power

Sets an MAP radio’s transmit power.

Syntax — set {ap port-listdap dap-num}radio {1 2} tx-power power-level

„ap port-list— List of ports connected to the MAP access points on which to set the transmit power.

„dap dap-num— Number of a Distributed MAP on which to set the transmit power.

„radio 1 — Radio 1 of the MAP.

„radio 2 — Radio 2 of the MAP. (This option does not apply to single-radio models.)

„tx-powerpower-level— Number of decibels in relation to 1 milliwatt (dBm). The valid values depend on the country of operation.

The maximum transmit power you can configure on any 3Com radio is the maximum allowed for the country in which you plan to operate the radio or one of the following values if that value is less than the country maximum: on an 802.11a radio, 11 dBm for channel numbers less than or equal to 64, or 10 dBm for channel numbers greater than 64; on an 802.11b/g radio, 16 dBm for all valid channel numbers for 802.11b, or 14 dBm for all valid channel numbers for 802.11g.

Defaults — The default transmit power on all MAP radio types is the highest setting allowed for the country of operation or highest setting supported on the hardware, whichever is lower.

Access — Enabled.

History —Introduced in MSS Version 3.0.

Usage — You also can configure a radio’s channel on the same command line. Use the channel option.

This command is not valid if dynamic power tuning (RF Auto-Tuning) is enabled.