set rfdetect ignore 467

This command is valid only on the seed switch of the Mobility Domain. The countermeasures take effect only if countermeasures are enabled for the Mobility Domain, using the set rfdetect countermeasures enable command.

This command does not become part of the configuration file when you save the configuration and therefore is not reloaded if the switch is restarted.

Examples — The following command begins countermeasures against rogue BSSID aa:bb:cc:11:22:33:

WX1200# set rfdetect countermeasures mac aa:bb:cc:11:22:33 success: set rfdetect countermeasures mac aa:bb:cc:11:22:33

See Also

„clear rfdetect countermeasures mac on page 456

„display rfdetect ignore on page 461

„set rf detect countermeasures on page 465

set rfdetect ignore Configures a list of known devices to ignore during an RF scan. MSS does not generate log messages or traps for the devices in the ignore list.

Syntax set rfdetect ignore mac-addr

„mac-addr— BSSID (MAC address) of the device to ignore.

Defaults — MSS reports all unknown BSSIDs detected during an RF scan.

Access — Enabled.

History —Introduced in MSS Version 3.0.

Usage — Use this command to identify third-party APs and other devices you are already aware of and do not want MSS to report following RF scans.

If you try to initiate countermeasures against a device on the ignore list, the ignore list takes precedence and MSS does not issue the countermeasures. Countermeasures apply only to rogue devices.

Page 467
Image 467
3Com 3CRWX120695A, 3CRWX440095A manual Syntax set rfdetect ignore mac-addr