3Com 3CRWX440095A, 3CRWX120695A manual Clear ap dap, Radio

234CHAPTER 9: MANAGED ACCESS POINT COMMANDS

clear {ap dap}	Disables a MAP radio and resets it to its factory default settings.
radio	Syntax — clear {ap port-listdap dap-num} radio {1 2
	all}
	„ ap port-list— List of ports connected to the MAP access point(s) on
		which to reset a radio.
	„ dap dap-num— Number of a Distributed MAP on which to reset a
		radio.
	„	radio 1 — Radio 1 of the MAP.
	„	radio 2 — Radio 2 of the MAP. (This option does not apply to
		single-radio models.)
	„	radio all — All radios on the MAP.

Defaults — The clear ap radio command resets the radio to the default settings listed in Table 44 and in Table 57 on page 292.

Table 44 Radio-Specific Parameters

Parameter	Default Value		Description
channel	„	802.11b — 6	Number of the channel in
	„	802.11a — Lowest	which a radio transmits and
			receives traffic
		valid channel number
		for the country of
		operation
tx-power	Highest setting allowed for		Transmit power of a radio, in
	the country of operation		decibels referred to
	or highest setting		1 milliwatt (dBm)
	supported on the
	hardware, whichever is
	lower.

antennatype	internal
	(The default for model
	MP-262 is ANT1060.)

External antenna model

Note: This parameter applies only to MAPs that support external antennas.

Access — Enabled

History —Introduced in MSS Version 3.0.