2ACCESS COMMANDS
This chapter describes access commands used to control access to the
Mobility Software System (MSS) command-line interface (CLI).
Commands by
Usage
This chapter presents access services commands alphabetically. Use
Table5 to located commands in this chapter based on their use.
disable Changes the CLI session from enabled mode to restricted access.
Syntax — disable
Defaults — None.
Access — Enabled.
History — Introduced in MSS Version 3.0.
Examples — The following command restricts access to the CLI for the
current session:
WX1200# disable
WX1200>
Tabl e 5 Access Commands by Usage
Type Command
Access Privileges “enable” on page34
“set enablepass” on page 35
“disable” on page 33
“quit” on page 34