3Com 3CRWX440095A, 3CRWX120695A manual Set radio-profile auto-tune power-backoff- timer

284CHAPTER 9: MANAGED ACCESS POINT COMMANDS

set radio-profile auto-tune power-backoff- timer

Sets the interval at which radios in a radio profile reduce power after temporarily increasing the power to maintain the minimum data rate for an associated client. At the end of each power-backoff interval, radios that temporarily increased their power reduce it by 1 dBm. The power backoff continues in 1 dBm increments after each interval until the power returns to expected setting.

Syntax — set radio-profile name auto-tune power-backoff-timer

seconds

„name — Radio profile name.

„seconds — Number of seconds radios wait before lowering the power by 1 dBm. You can specify from 0 to 65535 seconds.

Defaults — The default power-backoff interval is 10 seconds.

Access — Enabled.

History —Introduced in MSS Version 3.0.

A radio can increase power again if required to preserve the minimum data rate for an associated client.

Examples — The following command changes the power-backoff interval for radios in radio profile rp2 to 15 seconds:

WX4400# set radio-profile rp2 auto-tune power-backoff-timer 15

success: change accepted.

See Also

„set {ap dap} radio auto-tunemax-poweron page 270

„set {ap dap} radio auto-tune max- retransmissions on page 271

„set radio-profileauto-tunepower-configon page 285

„set radio-profileauto-tunepower-intervalon page 286