set rfdetect active-scan 465

 

 

set rfdetect

Disables or reenables active RF detection scanning on a WX switch. When

active-scan

active scanning is enabled, the MAP radios managed by the switch look

 

for rogue devices by sending probe any requests (probe requests with a

 

null SSID name), to solicit probe responses from other access points.

 

Syntax set rfdetect active-scan {enable disable}

 

„ enable Enables active RF detection scanning.

 

„ disable Disables active RF detection scanning.

 

Defaults — Active scanning is enabled by default.

 

Access — Enabled.

 

History —Introduced in MSS Version 3.0.

 

Usage — You can enter this command on any WX switch in the Mobility

 

Domain. The command takes effect only on that switch.

 

Examples — The following command disables active scanning on a WX

 

switch:

 

WX1200# set rfdetect active-scan disable

 

success: off-channel scanning is disabled.

 

 

set rf detect

Enables or disables countermeasures for the Mobility Domain.

countermeasures

Countermeasures are packets sent by a radio to prevent clients from

 

being able to use a rogue access point.

 

CAUTION: Countermeasures affect wireless service on a radio. When a

 

MAP radio is sending countermeasures, the radio is disabled for use by

 

network traffic, until the radio finishes sending the countermeasures.

Syntax set rfdetect countermeasures {enable disable}

„enable — Enables countermeasures.

„disable — Disables countermeasures.

Defaults — Countermeasures are disabled by default.

Access — Enabled.

History —Introduced in MSS Version 3.0.

Page 465
Image 465
3Com 3CRWX120695A, 3CRWX440095A manual Set rfdetect, Active-scan, Set rf detect