set port type ap 83

set port type ap Configures an WX switch port for an MAP access point.

CAUTION: When you set the port type for MAP use, you must specify the PoE state (enable or disable) of the port. Use the WX switch’s PoE to power 3Com MAP access points only. If you enable PoE on a port connected to another device, physical damage to the device can result.

Before configuring a port as an MAP access point port, you must use the set system countrycode command to set the IEEE 802.11 country-specific regulations on the WX switch. See “set system countrycode” on page 51.

For an MAP that is indirectly connected to the WX switch through an intermediate Layer 2 or Layer 3 network, use the set dap command to configure a Distributed MAP.

Before changing the port type from ap to wired-author from wired-authto ap, you must reset the port with the clear port type command.

Syntax set port type ap port-listmodel {ap2750 ap7250 ap8250 ap8750 mp-52 mp-101 mp-122 mp-241 mp-252 mp-262 mp-341 mp-352mp-372}

poe {enable disable} [radiotype {11a 11b 11g}]

„port-list— List of physical ports.

„model {ap2750 ap7250 ap8250 ap8750 mp-52 mp-101

mp-122 mp-241 mp-252 mp-262 mp-341 mp-352

mp-372}— MAP access point model:

„ap2750 — Contains one radio that can be configured through software for 802.11a or 802.11b/g.

„ap7250 — Contains one 802.11b/g radio.

„ap8250 — Contains one 802.11b/g radio. It also has the ability to have an additional radio installed in it.

„ap8750 — Contains one 802.11a radio and one 802.11b/g radio.

„mp-52— Contains one 802.11a radio and one 802.11b radio, with adjustable external antennas.

„mp-101— Contains one radio that can be configured through software for 802.11a or 802.11b.

Page 83
Image 83
3Com 3CRWX120695A, 3CRWX440095A manual Set port type ap