156CHAPTER 6: IP SERVICES COMMANDS

History —Introduced in MSS Version 3.0.

Usage — You must use an address that is configured on one of the WX switch’s VLANs.

To display the system IP address, use the display system command.

Examples — The following commands configure an IP interface on

VLAN taupe and configure the interface to be the system IP address:

WX4400# set interface taupe ip 10.10.20.20/24

success: set ip address 10.10.20.20 netmask 255.255.255.0 on vlan taupe WX4400# set system ip-address 10.10.20.20

success: change accepted.

See Also

„clear system ip-addresson page 115

„display system on page 42

„set interface on page 135

set timedate

Sets the time of day and date on the wireless LAN switch.

Syntax set timedate {date mmm dd yyyy [time hh:mm:ss]}

„date mmm dd yyyy — System date:

„mmm — month

„dd — day

„yyyy — year

„time hh:mm:ss — System time, in hours, minutes, and seconds.

Defaults — None.

Access — Enabled.

History —Introduced in MSS Version 3.0.

Usage — The day of week is automatically calculated from the day you set. The time displayed by the CLI after you type the command might be slightly later than the time you enter due to the interval between when you press Enter and when the CLI reads and displays the new time and date.

Page 156
Image 156
3Com 3CRWX440095A Set timedate, „ date mmm dd yyyy System date, „ time hhmmss System time, in hours, minutes, and seconds