342CHAPTER 10: STP COMMANDS

Examples — The following command enables port fast convergence on ports 2, 5, and 7:

WX1200# set spantree portfast port 2,4,7 enable success: change accepted.

See Also

„display spantree portfast on page 328

set spantree portpri Changes the STP priority of a network port or ports for selection as part of the path to the STP root bridge in the default VLAN on a wireless LAN switch.

Syntax set spantree portpri port-listpriority value

„port-list— List of ports. MSS changes the priority on the specified ports.

„priority value Priority value. You can specify a value from 0 (highest priority) through 255 (lowest priority).

Defaults — The default STP priority for all network ports is 128.

Access — Enabled.

History —Introduced in MSS Version 3.0.

Usage — This command applies only to the default VLAN (VLAN 1). To change the priority of a port in another VLAN, use the set spantree portvlanpri command.

Examples — The following command sets the priority of ports 3 and 4 to 48:

WX1200# set spantree portpri 3-4 priority 48 success: change accepted.

See Also

„clear spantree portpri on page 321

„clear spantree portvlanpri on page 322

„display spantree on page 324

„set spantree portvlanpri on page 344

Page 342
Image 342
3Com 3CRWX440095A manual See Also „ display spantree portfast on, Syntax set spantree portpri port-listpriority value