display dap connection 253

 

„ set radio-profileauto-tunechannel-intervalon page 283

 

„ set radio-profileauto-tunepower-backoff- timer on page 284

 

„ set radio-profileauto-tunepower-configon page 285

 

„ set radio-profileauto-tunepower-intervalon page 286

 

 

display dap

Displays the system IP address of the WX switch that has the active data

connection

connection for a Distributed MAP.

 

Syntax display dap connection

 

[dap-num serial-idserial-ID]

 

„ dap-num— Number of a Distributed MAP for which to display

 

information about its active connection.

 

„ serial-idserial-ID— MAP access point serial ID.

 

Defaults — None.

 

Access — Enabled.

 

History —Introduced in MSS Version 3.0.

 

Usage — The serial-idparameter displays the active connection for the

 

specified Distributed MAP even if that MAP is not configured on this WX

 

switch. If you instead use the command with the dap-numparameter or

 

without a parameter, connection information is displayed only for

 

Distributed MAPs that are configured on this WX switch.

 

If a Distributed MAP is configured on this WX switch (or another WX

 

switch in the same Mobility Domain) but does not have an active

 

connection, the command does not display information for the MAP. To

 

show configured Distributed MAPs regardless of connection status, use

 

the display dap global command.

Examples — The following command displays information for all Distributed MAPs configured on this WX switch that have active connections:

WX1200# display

dap connection

 

Total number of

entries:

2

WX IP Address

DAP Serial Id

DAP IP

Address

--- -----------

---------------

---------------

2 M9DE48B012F00 10.10.2.27

10.3.8.111

Page 253
Image 253
3Com 3CRWX120695A, 3CRWX440095A manual Display dap, Connection