3Com 3CRWX120695A, 3CRWX440095A manual Values, Date is within the summertime period, Following

set system ip-address 155

	Usage — You must first set the time zone with the set timezone
	command for the offset to work properly without the start and end
	values.
	Configure summertime before you set the time and date. Otherwise,
	summertime’s adjustment of the time will make the time incorrect, if the
	date is within the summertime period.
	Examples — To enable summertime and set the summertime time zone
	to PDT (Pacific Daylight Time), type the following command:
	WX1200# set summertime PDT
	success: change accepted
	See Also
	„ clear summertime on page 115
	„ clear timezone on page 116
	„ display summertime on page 130
	„ display timedate on page 130
	„ display timezone on page 131
	„ set timedate on page 156
	„ set timezone on page 157
set system	Configures the system IP address. The system IP address determines the
ip-address	interface or source IP address MSS uses for system tasks, including the
	following:
	„ Mobility domain operations
	„ Topology reporting for dual-homed MAP access points
	„ Default source IP address used in unsolicited communications such as
	AAA accounting reports and SNMP traps

Syntax — set system ip-address ip-addr

„ip-addr— IP address, in dotted decimal notation. The address must be configured on one of the WX switch’s VLANs.

Defaults — None.

Access — Enabled.