3Com 3CRWX120695A manual „ set port poe on, Specified ports, All four ports of a WX4400 switch

display port preference 65

Table 12 Output for display port poe (continued)

Field	Description
Link status	Link status of the port:
	„ up—The port is connected.
	„ down—The port is not connected.
Port type	Port type:
	„ MAP —The port is an MAP access port.
	„ - (The port is not an MAP access port.)
PoE config	PoE state:
	„	enabled
	„	disabled
PoE Draw	Power draw on the port, in watts.
	For 10/100 Ethernet ports on which PoE is disabled,
	this field displays off. For gigabit Ethernet ports, this
	field displays invalid, because PoE is not supported
	on gigabit Ethernet ports.
	The value overcurrent indicates a PoE problem such
	as a short in the cable.

	See Also
	„ set port poe on page 79
display port	Displays the interface preferences set on WX4400 gigabit Ethernet ports.
preference	Syntax — display port preference [port-list]
	„ port-list— List of physical ports. MSS displays the preference for all
	the specified ports.
	Defaults — None.
	Access — All.
	History — Introduced in MSS Version 3.0.
	Usage — This command applies only to the WX4400.
	Examples — The following command displays the preference settings on
	all four ports of a WX4400 switch:

WX4400# display port preference