3Com 3CRWX120695A, 3CRWX440095A manual See Also „ display igmp querier on

set igmp receiver 367

Examples — The following example enables the pseudo-querier on the orange VLAN:

WX1200# set igmp querier enable vlan orange success: change accepted.

See Also

„display igmp querier on page 353

set igmp receiver Adds or removes a network port in the list of ports on which a WX forwards traffic to multicast receivers. Static multicast receiver ports are immediately added to or removed from the list of receiver ports and do not age out.

Syntax — set igmp receiver port port-list{enable disable}

„port port-list— Network port list. MSS adds the specified ports to the list of static multicast receiver ports.

„enable — Adds the port to the list of static multicast receiver ports.

„disable — Removes the port from the list of static multicast receiver ports.

Defaults — By default, no ports are static multicast receiver ports.

Access — Enabled.

History — Introduced in MSS Version 3.0.

Usage — You cannot add MAP access ports or wired authentication ports as static multicast ports. However, MSS can dynamically add these port types to the list of multicast ports based on multicast traffic.

Examples — The following command adds port 7 as a static multicast receiver port:

WX1200# set igmp receiver port 7 enable success: change accepted.

The following command removes port 7 from the list of static multicast receiver ports:

WX1200# set igmp receiver port 7 disable success: change accepted.