3Com 3CRWX440095A, 3CRWX120695A manual Clear rfdetect, Mac, Countermeasures mac command

456CHAPTER 17: RF DETECTION COMMANDS

Table 85 RF Detection Commands by Usage (continued)

Type	Command
	clear rfdetect countermeasures mac on
	page 456
Known Devices List	set rfdetect ignore on page 467
(Ignore List)
	display rfdetect ignore on page 461
	clear rfdetect ignore on page 457
Active Scanning	set rfdetect active-scanon page 465

clear rfdetect	Removes a rogue BSSID from the list configured by the set rfdetect
countermeasures	countermeasures mac command.
mac	Syntax — clear rfdetect countermeasures mac {mac-addrall}
	„ mac-addr— Basic service set identifier (BSSID) of the rogue. Enter the
	BSSID in MAC address format, using a colon between each octet (for
	example: aa:bb:cc:dd:ee:ff).
	„ all — Stops countermeasures against all the BSSIDs specified by set
	rfdetect countermeasures mac commands.
	Defaults — None.
	Access — Enabled.
	History —Introduced in MSS Version 3.0.
	Usage — This command applies only to rogue devices that you explicitly
	started countermeasures against using the set rfdetect
	countermeasures mac command. This command is valid only on the
	seed switch of the Mobility Domain, and does not become part of the
	configuration file when you save the configuration and therefore is not
	reloaded if the switch is restarted.
	After you type the first set rfdetect countermeasures mac command,
	MSS does not issue countermeasures against any devices except the ones
	you specify using this command. To resume normal countermeasures
	operation, where MSS automatically issues countermeasures against
	detected rogues, use the clear rfdetect countermeasures mac all
	command.