3Com 3CRWX440095A manual Load config, Running configuration with the commands in the loaded file

482CHAPTER 18: FILE MANAGEMENT COMMANDS

Table 94 Output for display version (continued)

Field	Description
Serial #	MAP serial number.
Versions	MAP hardware, firmware, and software versions.

	See Also
	„ display boot on page 477
load config	Loads configuration commands from a file and replaces the WX switch’s
	running configuration with the commands in the loaded file.
	CAUTION: This command completely removes the running configuration
	and replaces it with the configuration contained in the file. 3Com
	recommends that you save a copy of the current running configuration to
	a backup configuration file before loading a new configuration.

Syntax — load config [url]

„url — Filename. Specify between 1 and 128 alphanumeric characters, with no spaces.

If the file is in a subdirectory, specify the subdirectory name, followed by a forward slash, in front of the filename. For example: backup_configs/config_c.

Defaults — The default file location is nonvolatile storage.

The current version supports loading a configuration file only from the switch’s nonvolatile storage. You cannot load a configuration file directly from a TFTP server.

If you do not specify a filename, MSS uses the same configuration filename that was used for the previous configuration load. For example, if the WX switch used configuration for the most recent configuration load, MSS uses configuration again unless you specify a different filename. To display the filename of the configuration file MSS loaded during the last reboot, use the display boot command.

Access — Enabled.

History —Introduced in MSS Version 3.0.