set radius server 415

Usage — The WX system IP address must be set before you use this command.

Examples — The following command sets the WX system IP address as the address of the RADIUS client:

WX4400# set radius client system-ip success: change accepted.

See Also

„clear radius client system-ipon page 411

„set system ip-addresson page 53

set radius server Configures RADIUS servers and their parameters. By default, the WX switch automatically sets all these values except the password (key).

Syntax set radius server server-name

[address ip-address][auth-port port-number][acct-port port-number] [timeout seconds] [retransmit number] [deadtime minutes] [key string] [author-password password]

„server-nameUnique name for this RADIUS server. Enter an alphanumeric string of up to 32 characters, with no blanks.

„address ip-address— IP address of the RADIUS server. Enter the address in dotted decimal notation.

„auth-portport-number— UDP port that the WX switch uses for authentication and authorization.

„acct-portport-number — UDP port that the WX switch uses for accounting.

„timeout seconds — Number of seconds the WX switch waits for the RADIUS server to respond before retransmitting. You can specify from 1 to 65,535 seconds.

„retransmit number — Number of transmission attempts made before declaring an unresponsive RADIUS server unavailable. You can specify from 1 to 100 retries.

„deadtime minutes — Number of minutes the WX switch waits after declaring an unresponsive RADIUS server unavailable before retrying that RADIUS server. Specify between 0 (zero) and 1440 minutes

Page 415
Image 415
3Com 3CRWX120695A, 3CRWX440095A manual WX4400# set radius client system-ip success change accepted