3Com 3CRWX440095A, 3CRWX120695A manual Set ap dap radio min-client-rate

274CHAPTER 9: MANAGED ACCESS POINT COMMANDS

This command is not valid if dynamic channel tuning (RF Auto-Tuning) is enabled.

Examples — The following command configures the channel on the

802.11a radio on the MAP access point connected to port 5:

WX1200# set ap 5 radio 1 channel 36 success: change accepted.

The following command configures the channel and transmit power on the 802.11b/g radio on the MAP access point connected to port 1:

WX1200# set ap 1 radio 1 channel 1 tx-power 10 success: change accepted.

See Also

„“display {ap dap} config” on page 237

„set {ap dap} radio tx-poweron page 278

set {ap dap} radio min-client-rate

Sets the minimum rate at which a radio is allowed to transmit traffic to clients. The radio automatically increases its transmit power when necessary to maintain at least the minimum rate with an associated client.

Syntax — set {ap port-listdap dap-num} radio {1 2}

auto-tune min-client-rate rate

„ap port-list— List of ports connected to the MAP access points on which to set the channel.

„dap dap-num— Number of a Distributed MAP on which to set the channel.

„radio 1 — Radio 1 of the MAP.

„radio 2 — Radio 2 of the MAP. (This option does not apply to single-radio models.)

„rate — Minimum data rate, in megabits per second (Mbps). The valid values depend on the radio type:

„For 802.11g radios—54, 48, 36, 24, 18, 12, 11, 9, 6, 5.5, 2, or 1

„For 802.11b radios—11, 5.5, 2, or 1

„For 802.11a radios—54, 48, 36, 24, 18, 12, 9, or 6