3Com 3CRWX440095A, 3CRWX120695A manual Defaults for Service Profile Parameters

296CHAPTER 9: MANAGED ACCESS POINT COMMANDS

See Also

„set radio-profile mode on page 291

„display radio-profileon page 257

set radio-profileMaps a service profile to a radio profile. All radios that use the radio

service-profileprofile also use the parameter settings, including SSID and encryption settings, in the service profile.

Syntax — set radio-profile name service-profile name

„radio-profilename — Radio profile name of up to 16 alphanumeric characters, with no spaces.

„service-profilename — Service profile name of up to 16 alphanumeric characters, with no spaces.

Defaults — A radio profile does not have a service profile associated with it by default. In this case, the radios in the radio profile use the default settings for parameters controlled by the service profile. Table 58 lists the parameters controlled by a service profile and their default values.

Table 58 Defaults for Service Profile Parameters

		Radio Behavior When Parameter Set
Parameter	Default Value	to Default Value
auth-dot1x	enable	When the Wi-Fi Protected Access (WPA)
		information element (IE) is enabled, uses
		802.1X to authenticate WPA clients.
auth-fallthru	web-auth	Uses WebAAA for users who do not
		match an 802.1X or MAC authentication
		rule for the SSID requested by the user.
auth-psk	disable	Does not support using a preshared key
		(PSK) to authenticate WPA clients.
beacon	enable	Sends beacons to advertise the SSID
		managed by the service profile.
cipher-ccmp	disable	Does not use Counter with Cipher Block
		Chaining Message Authentication Code
		Protocol (CCMP) to encrypt traffic sent to
		WPA clients.