3Com 3CRWX120695A, 3CRWX440095A manual Set ap dap radio channel, Sets an MAP radio’s channel

set {ap dap} radio channel 273

Examples — The following command changes the max-retransmissions value to 20:

WX1200# set ap 6 radio 1 auto-tune max-retransmissions 20 success: change accepted.

See Also

„set {ap dap} radio auto-tunemax-poweron page 270

„set radio-profileauto-tunepower-backoff- timer on page 284

„set radio-profileauto-tunepower-configon page 285

„set radio-profileauto-tunepower-intervalon page 286

set {ap dap} radio channel

Sets an MAP radio’s channel.

Syntax — set {ap port-listdap dap-num}radio {1 2}

channel channel-number

„ap port-list— List of ports connected to the MAP access points on which to set the channel.

„dap dap-num— Number of a Distributed MAP on which to set the channel.

„radio 1 — Radio 1 of the MAP.

„radio 2 — Radio 2 of the MAP. (This option does not apply to single-radio models.)

„channel channel-number— Channel number. The valid channel numbers depend on the country of operation.

Defaults — The default channel depends on the radio type:

„The default channel number for 802.11b/g is 6.

„The default channel number for 802.11a is the lowest valid channel number for the country of operation.

Access — Enabled.

History —Introduced in MSS Version 3.0.

Usage — You can configure a radio’s transmit power on the same command line. Use the tx-poweroption.