140CHAPTER 6: IP SERVICES COMMANDS

set ip https server Enables the HTTPS server on a wireless LAN switch. The HTTPS server is required for Web Manager access to the switch.

CAUTION: If you disable the HTTPS server, Web Manager access to the

WX switch is also disabled.

Syntax set ip https server {enable disable}

„enable — Enables the HTTPS server.

„disable — Disables the HTTPS server.

Defaults — The HTTPS server is disabled by default.

Access — Enabled.

History — The default is changed to disabled in 3.1. In addition, the

HTTPS server is no longer required for WebAAA.

Examples — The following command enables the HTTPS server on a WX switch:

WX1200# set ip https server enable success: change accepted.

See Also

„clear ip telnet on page 112

„display ip https on page 121

„display ip telnet on page 125

„set ip telnet on page 146

„set ip telnet server on page 147

set ip route

Adds a static route to the IP route table.

Syntax set ip route {default ip-addr mask

ip-addr/mask-length}gateway metric

„default — Default route. A WX switch uses the default route if an explicit route is not available for the destination.

Default is an alias for IP address 0.0.0.0/0.

Page 140
Image 140
3Com 3CRWX440095A, 3CRWX120695A manual Set ip route, WX switch is also disabled, Adds a static route to the IP route table