466CHAPTER 17: RF DETECTION COMMANDS

Usage — This command is valid only on the seed switch of the Mobility

Domain.

Examples — The following command enables countermeasures for the

Mobility Domain managed by this seed switch:

WX1200# set rfdetect countermeasures enable success: countermeasures are now enabled.

See Also

„clear rfdetect countermeasures mac on page 456

„display rfdetect ignore on page 461

set rfdetect countermeasures mac on page 466

set rfdetect countermeasures mac

Starts countermeasures against a specific rogue.

Syntax set rfdetect countermeasures mac mac-addr

„mac-addr— Basic service set identifier (BSSID) of the rogue. Enter the BSSID in MAC address format, using a colon between each octet (for example: aa:bb:cc:dd:ee:ff).

Defaults — None.

Access — Enabled.

History —Introduced in MSS Version 3.0.

Usage — Use this command to immediately begin countermeasures against a specific rogue in the rogue list. The MAC address you specify must be in the list of rogues generated by RF detection scans. MSS can issue countermeasures only against a device that is in the rogue list.

You can start countermeasures against more than one BSSID by typing additional set rfdetect countermeasures mac commands.

After you type the first set rfdetect countermeasures mac command, MSS does not issue countermeasures against any devices except the ones you specify using this command. To resume normal countermeasures operation, where MSS automatically issues countermeasures against detected rogues, use the clear rfdetect countermeasures mac all command.

Page 466
Image 466
3Com 3CRWX440095A, 3CRWX120695A manual Set rfdetect countermeasures mac, Starts countermeasures against a specific rogue