3Com 3CRWX120695A, 3CRWX440095A manual Set vlan, Tunnel-affinity

set vlan tunnel-affinity 105

	Usage — You can combine this command with the set port name
	command to assign the name and add the ports at the same time.
	If you do not specify a tag value, the WX switch sends untagged frames
	for the VLAN. If you do specify a tag value, the WX sends tagged frames
	only for the VLAN.
	If you do specify a tag value, 3Com recommends that you use the same
	value as the VLAN number. MSS does not require the VLAN number and
	tag value to be the same but some other switches do.
	Examples — The following command assigns the name beige to VLAN
	11 and adds ports 1 through 3 to the VLAN:
	WX1200# set vlan 11 name beige port 1-3
	success: change accepted.
	The following command adds port 6 to VLAN beige and assigns tag value
	86 to the port:
	WX1200# set vlan beige port 6 tag 86
	success: change accepted.
	See Also
	„ clear vlan on page 91
	„ display vlan config on page 100
	„ set vlan name on page 103
set vlan	Changes a wireless LAN switch’s preferability within a mobility domain
tunnel-affinity	for tunneling user traffic for a VLAN. When a user roams to a WX switch
	that is not a member of the user’s VLAN, the WX can forward the user
	traffic by tunneling to another WX switch that is a member of the VLAN.

Syntax — set vlan vlan-idtunnel-affinity num

„vlan-id— VLAN name or number.

„num — Preference of this switch for forwarding user traffic for the VLAN. You can specify a value from 1 through 10. A higher number indicates a greater preference.

Defaults — Each VLAN on a WX switch’s network ports has an affinity value of 5 by default.