3Com 3CRWX440095A, 3CRWX120695A manual Set radio-profile auto-tune channel-holddown

282CHAPTER 9: MANAGED ACCESS POINT COMMANDS

success: change accepted.

See Also

„set radio-profileauto-tunechannel-holddownon page 282

„set radio-profileauto-tunechannel-intervalon page 283

„set radio-profileauto-tunepower-configon page 285

set radio-profile auto-tune channel-holddown

Sets the minimum number of seconds a radio in a radio profile must remain at its current channel assignment before RF Auto-Tuning can change the channel. The channel holddown provides additional stability to the network by preventing the radio from changing channels too rapidly in response to spurious RF anomalies such as short-duration channel interference.

Syntax — set radio-profile name auto-tune channel-holddown

holddown

„name — Radio profile name.

„holddown — Minimum number of seconds a radio must remain on its current channel setting before RF Auto-Tuning is allowed to change the channel. You can specify from 0 to 65535 seconds.

Defaults — The default RF Auto-Tuning channel holddown is 900 seconds.

Access — Enabled.

History —Introduced in MSS Version 3.0.

Usage — The channel holddown applies even if RF anomalies occur that normally cause an immediate channel change.

Examples — The following command changes the channel holddown for radios in radio profile rp2 to 600 seconds:

WX4400# set radio-profile rp2 auto-tune channel-holddown 600 success: change accepted.

See Also

„set radio-profileauto-tunechannel-configon page 281

„set radio-profileauto-tunechannel-intervalon page 283