3Com 3CRWX120695A, 3CRWX440095A manual Set ip route

set ip route 141

„ip-addr mask — IP address and subnet mask for the route destination, in dotted decimal notation (for example, 10.10.10.10 255.255.255.0).

„ip-addr/mask-length— IP address and subnet mask length in CIDR format (for example, 10.10.10.10/24).

„gateway — IP address, DNS hostname, or alias of the next-hop router.

„metric — Cost for using the route. You can specify a value from 0 through 2,147,483,647. Lower-cost routes are preferred over higher-cost routes.

Defaults — The HTTPS server is enabled by default.

Access — Enabled.

Usage — MSS can use a static route only if a direct route in the route table resolves the static route. MSS adds routes with next-hop types Local and Direct when you add an IP interface to a VLAN, if the VLAN is up. If one of these added routes can resolve the static route, MSS can use the static route.

Before you add a static route, use the display interface command to verify that the WX switch has an IP interface in the same subnet as the route’s next-hop router. If not, the VLAN:Interface field of the display ip route command output shows that the route is down.

You can configure a maximum of 4 routes per destination. This includes default routes, which have destination 0.0.0.0/0. Each route to a given destination must have a unique gateway address. When the route table contains multiple default or explicit routes to the same destination, MSS uses the route with the lowest cost. If two or more routes to the same destination have the lowest cost, MSS selects the first route in the route table.

When you add multiple routes to the same destination, MSS groups the routes and orders them from lowest cost at the top of the group to highest cost at the bottom of the group. If you add a new route that has the same destination and cost as a route already in the table, MSS places the new route at the top of the group of routes with the same cost.