3Com 3CRWX120695A Set port speed, Changes the speed of a port, WX4400# set port preference 2 rj45

set port speed 81

Access — Enabled.

History — Introduced in MSS Version 3.0.

Usage — This command applies only to the WX4400.

If you set the preference to RJ-45 (copper) on a port that already has an active fiber link, MSS immediately changes the link to the copper interface.

Examples — The following command sets the preference of port 2 on a

WX4400 to RJ-45 (copper):

WX4400# set port preference 2 rj45

See Also

„clear port preference on page 60

„display port preference on page 65

set port speed Changes the speed of a port.

Syntax — set port speed port-list{10 100 1000 auto}

„port-list— List of physical ports. MSS sets the port speed on all the specified ports.

„10 — Sets the port speed of a 10/100 Ethernet port to 10 Mbps and sets the operating mode to full-duplex.

„100 — Sets the port speed of a 10/100 Ethernet port to 100 Mbps and sets the operating mode to full-duplex.

„1000 — Sets the port speed of a gigabit Ethernet port to 1000 Mbps and sets the operating mode to full-duplex.

„auto — Enables a port to detect the speed and operating mode of the traffic on the link and set itself accordingly.

Defaults — All ports are set to auto.

Access — Enabled.

History — Introduced in MSS Version 3.0.