3Com 3CRWX440095A, 3CRWX120695A manual Set ap dap radio auto-tune max-power

270CHAPTER 9: MANAGED ACCESS POINT COMMANDS

Usage — This command applies only to MAP models MP-372, MP-341, MP-352, and MP-262. External 802.11a antennas are supported only on model MP-372.

Examples — The following command configures the 802.11b/g radio on

Distributed MAP 1 to use antenna model ANT1060:

WX4400# set dap 1 radio 1 antennatype ANT1060 success: change accepted.

See Also

„“display {ap dap} config” on page 237

set {ap dap} radio auto-tune max-power

Sets the maximum power that RF Auto-Tuning can set on a radio.

Syntax — set {ap port-listdap dap-num} radio {1 2}

auto-tune max-power power-level

„ap port-list— List of ports connected to the MAP access points on which to set the channel.

„dap dap-num— Number of a Distributed MAP on which to set the channel.

„radio 1 — Radio 1 of the MAP.

„radio 2 — Radio 2 of the MAP. (This option does not apply to single-radio models.)

„power-level— Maximum power setting RF Auto-Tuning can assign to the radio, expressed as the number of decibels in relation to 1 milliwatt (dBm). You can specify a value from 1 up to the maximum value allowed for the country of operation.

The power-levelcan be a value from 1 to 20.

Defaults — The default maximum power setting that RF Auto-Tuning can set on a radio is the highest setting allowed for the country of operation or highest setting supported on the hardware, whichever is lower.

Access — Enabled.

History —Introduced in MSS Version 3.0.