3Com 3CRWX120695A, 3CRWX440095A manual Portvlancost command

set spantree portfast 341

	Access — Enabled.
	History —Introduced in MSS Version 3.0.
	Usage — This command applies only to the default VLAN (VLAN 1). To
	change the cost of a port in another VLAN, use the set spantree
	portvlancost command.
	Examples — The following command changes the cost on ports 3 and 4
	to 20:
	WX1200# set spantree portcost 3,4 cost 20
	success: change accepted.
	See Also
	„ clear spantree portcost on page 320
	„ clear spantree portvlancost on page 321
	„ display spantree on page 324
	„ display spantree portvlancost on page 329
	„ set spantree portvlancost on page 343
set spantree	Enables or disables STP port fast convergence on one or more ports on a
portfast	wireless LAN switch.
	Syntax — set spantree portfast port port-list{enable disable}
	„ port port-list— List of ports. MSS enables the feature on the
	specified ports.
	„ enable — Enables port fast convergence.
	„ disable — Disables port fast convergence.
	Defaults — STP port fast convergence is disabled by default.
	Access — Enabled.
	History —Introduced in MSS Version 3.0.
	Usage — Use port fast convergence on ports that are directly connected
	to servers, hosts, or other MAC stations.