3Com 3CRWX120695A, 3CRWX440095A Bridge for a specific Vlan on a wireless LAN switch, Type. See on

set spantree portvlancost 343

set spantree	Changes the cost of a network port or ports on paths to the STP root
portvlancost	bridge for a specific VLAN on a wireless LAN switch.
	Syntax — set spantree portvlancost port-listcost cost {all
	vlan vlan-id}
	„ port-list— List of ports. MSS applies the cost change to all the
	specified ports.
	„ cost cost — Numeric value. You can specify a value from 1 through
	65,535. STP selects lower-cost paths over higher-cost paths.
	„ all — Changes the cost on all VLANs.
	„ vlan vlan-id— VLAN name or number. MSS changes the cost on
	only the specified VLAN.
	Defaults — The default port cost depends on the port speed and link
	type. (See Table 59 on page 319.)
	Access — Enabled.
	History —Introduced in MSS Version 3.0.
	Examples — The following command changes the cost on ports 3 and 4
	to 20 in VLAN mauve:
	WX1200# set spantree portvlancost 3,4 cost 20 vlan mauve
	success: change accepted.
	See Also
	„ clear spantree portcost on page 320
	„ clear spantree portvlancost on page 321
	„ display spantree on page 324
	„ display spantree portvlancost on page 329
	„ set spantree portcost on page 340