set radio-profile long-retry 289

Usage — You must disable all radios that are using a radio profile before you can change parameters in the profile. Use the set radio-profile mode command.

Examples — The following command changes the fragmentation threshold for radio profile rp1 to 1500 bytes:

WX4400# set radio-profile rp1 frag-threshold 1500 success: change accepted.

See Also

„display radio-profileon page 257

„set radio-profile mode on page 291

set radio-profileChanges the long retry threshold for the MAP radios in a radio profile.

long-retryThe long retry threshold specifies the number of times a radio can send a long unicast frame without receiving an acknowledgment. A long unicast frame is a frame that is equal to or longer than the Request-to-Send (RTS) threshold.

Syntax set radio-profile name long-retry threshold

„name — Radio profile name.

„threshold — Number of times the radio can send the same long unicast frame. You can enter a value from 1 through 15.

Defaults — The default long unicast retry threshold for MAP radios is 5 attempts.

Access — Enabled.

History —Introduced in MSS Version 3.0.

Usage — You must disable all radios that are using a radio profile before you can change parameters in the profile. Use the set radio-profile mode command.

Examples — The following command changes the long retry threshold for radio profile rp1 to 8:

WX4400# set radio-profile rp1 long-retry 8 success: change accepted.

Page 289
Image 289
3Com 3CRWX120695A, 3CRWX440095A manual Syntax set radio-profile name long-retry threshold