3Com 3CRWX440095A, 3CRWX120695A Display config, Describes the fields in the display boot output

478CHAPTER 18: FILE MANAGEMENT COMMANDS

Table 93 describes the fields in the display boot output.

Table 93 Output for display boot

	Field		Description
	Configured boot		Boot partition and image filename MSS will use to boot next
	image		time the software is rebooted.
	Configured boot		Configuration filename MSS will use to boot next time the
	configuration		software is rebooted.
	Booted version		Software version the switch is running.
	Booted image		Boot partition and image filename MSS used the last time
			the software was rebooted. MSS is running this software
			image.
	Booted configuration		Configuration filename MSS used to load the configuration
			the last time the software was rebooted.
	See Also
	„ display version on page 480
	„ reset system on page 485
	„ set boot configuration-fileon page 488
display config	Displays the configuration running on the WX switch.
	Syntax — display config [area area] [all]
	„ area area — Configuration area. You can specify one of the
	following:
	„	aaa
	„	acls
	„	ap
	„	arp
	„	eapol
	„	httpd
	„	ip
	„	ip-config
	„	log
	„	mobility-domain
	„	ntp