3Com 3CRWX120695A, 3CRWX440095A Set, Mode member, Seed-ip, „ display mobility-domain config on

	set mobility-domain member 227
set	On the seed WX switch, adds a member to the list of Mobility Domain
mobility-domain	members. If the current WX switch is not configured as a seed, this
member	command is rejected.
	Syntax — set mobility-domain member ip-addr
	„ ip-addr— IP address of the Mobility Domain member in dotted
	decimal notation.
	Defaults — None.
	Access — Enabled.
	History —Introduced in MSS Version 3.0.
	Usage — This command must be entered from the seed WX switch.
	Examples — The following commands add three WX switches with the
	IP addresses 192.168.1.8, 192.168.1.9, and 192.168.1.10 as members of
	a Mobility Domain whose seed is the current WX switch:
	WX4400# set mobility-domain member 192.168.1.8
	success: change accepted.
	WX4400# set mobility-domain member 192.168.1.9
	success: change accepted.
	WX4400# set mobility-domain member 192.168.1.10
	success: change accepted.
	See Also
	„ clear mobility-domain member on page 224
	„ display mobility-domain config on page 225
	„ set mobility-domain mode seed domain-nameon page 228
set	On a nonseed WX switch, sets the IP address of the seed WX switch. This
mobility-domain	command is used on a member WX to configure it as a member. If the
mode member	WX switch is currently part of another Mobility Domain or using another
seed-ip	seed, this command overwrites that configuration.
	Syntax — set mobility-domain mode member seed-ip ip-addr
	„ ip-addr— IP address of the Mobility Domain member, in dotted
	decimal notation.