3Com 3CRWX440095A, 3CRWX120695A manual Set log

504CHAPTER 20: SYSTEM LOG COMMANDS

	Defaults — None.
	Access — Enabled.
	History — Introduced in MSS Version 3.0.
	Examples — Type the following command to see the facilities for which
	you can view event messages archived in the buffer:
WX4400# display log trace facility ?
<facility name>	Select one of: KERNEL, AAA, SYSLOGD, ACL, APM, ARP,

ASO, BOOT, CLI, CLUSTER, COPP, CRYPTO, DOT1X, ENCAP, ETHERNET, GATEWAY, HTTPD, IGMP, IP, MISC, NOSE, NP, RAND, RESOLV, RIB, ROAM, ROGUE, SM, SNMPD, SPAN, STORE, SYS, TAGMGR, TBRIDGE, TCPSSL, TELNET, TFTP, TLS, TUNNEL, VLAN, X509, XML, MAP,

RAPDA, WEBVIEW, EAP, PORTCONFIG, FP.

	See Also
	„ clear log on page 499
	„ display log config on page 502
set log	Enables or disables logging of WX and MAP events to the WX log buffer
	or other logging destination and sets the level of the events logged. For
	logging to a syslog server only, you can also set the facility logged.
	Syntax — set log {buffer console current server ip-addr
	sessions trace} [severity severity-level]enable disable]
	Syntax — set log server ip-addr[severity severity-level
	[local-facility facility-level]] [enable disable]
	„ buffer — Sets log parameters for the log buffer in nonvolatile
	storage.
	„ console — Sets log parameters for console sessions.
	„ current — Sets log parameters for the current Telnet or console
	session. These settings are not stored in nonvolatile memory.
	„ server ip-addr— Sets log parameters for a syslog server. Specify an
	address in dotted decimal notation.
	„ sessions — Sets the default log values for Telnet sessions. You can
	set defaults for the following log parameters:
	„ Severity