Briggs & Stratton 30219 manual Engine Technical Information, Product Specifications, Power Ratings

SPECIFICATIONS

ENGINE TECHNICAL

INFORMATION

This is a single cylinder, overhead valve(OHV), air cooled engine. It is a low emissions engine.

In the State of California, Model Series 150000 engines are certified by the California Air Resources Board to meet emissions standards for 250 hours. Such certification does not grant the purchaser, owner or operator of this engine any additional warranties with respect to the performance or operational life of this engine.The engine is warranted solely according to the product and emissions warranties stated elsewhere in this manual.

PRODUCT

SPECIFICATIONS

Generator Specifications

Starting Wattage	.6,250 Watts
Wattage	5,000 Watts
Rated AC Load Current:
At 120 Volts	. .41.6 Amps
Phase	. . . .1–phase
Rated Frequency	. . .60 Hertz
Shipping Weight	. . . .140 lbs.

Power Ratings

*The power ratings for an individual engine model are initially developed by starting with SAE (Society of Automotive Engineers) code J1940 (Small Engine Power & Torque Rating Procedure) (Revision 2002-05). Given both the wide array of products on which our engines are placed, and the variety of environmental issues applicable to operating the equipment, it may be that the engine you have purchased will not develop the rated horsepower when used in a piece of power equipment (actual “on-site” power).This difference is due to a variety of factors including, but not limited to, the following: differences in altitude, temperature, barometric pressure, humidity, fuel, engine lubrication, maximum governed engine speed, individual engine to engine variability, design of the particular piece of power equipment, the manner in which the engine is operated, engine run-in to reduce friction and clean out of combustion chambers, adjustments to the valves and carburetor, and other factors.The power ratings may also be adjusted based on comparisons to other similar engines utilized in similar applications, and will therefore not necessarily match the values derived using the foregoing codes.

Engine Specifications

Gross* Horsepower . . . . . . . . . . . . . . . . . 8.0 at 3600 rpm Bore . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2.97 in. (75mm) Stroke . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2.20 in. (56mm) Displacement . . . . . . . . . . . . . . . . . . . . . . 15.22 in. (249 cc)

Spark Plug

Type: . . . . . . . . . . . . Champion RC12YC or Equivalent

Set Gap To: . . . . . . . . . . . . . . . . . . . 0.030inch (0.76mm)

Armature Air Gap: . . . . . . . . . . . . . . . . . . . . 0.010-0.014 in. (0.25-0.36mm)

Valve clearance with valve springs installed and piston 1/4 in. (6 mm) past top dead center (check when engine is cold).

Intake . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 0.004-0.006 in. (0.10-0.15 mm)

Exhaust . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 0.009-0.011 in. (0.23-0.28 mm)

Fuel Capacity . . . . . . . . . . . . . . . . . . . . . . . . . 4 U.S. gallons Oil Capacity . . . . . . . . . . . . . . . . . . . .20 Ounces (.6 Liters)

NOTE: For practical operation, the generator load should not exceed 85% of rated wattage. Engine gross horsepower will decrease 3-1/2% for each 1,000 feet (300 meters) above sea level and 1% for each 10° F (5.6° C) above 77° F

(25° C). It should operate satisfactorily at an angle up to 15°.

12