3Com 3CRWX120695A, 3CRWX440095A manual Set ap dap radio min-client-rate

set {ap dap} radio min-client-rate 275

Defaults — The default minimum data transmit rate depends on the radio type:

„The default minimum data rate for 802.11b/g and 802.11b radios is 5.5 Mbps.

„The default minimum data rate for 802.11a radios is 24 Mbps.

Access — Enabled.

History —Introduced in MSS Version 3.0.

Usage — If the data rate for traffic sent by a radio to an associated client falls below the default minimum rate, the radio increases power, in

1 dBm increments, until all clients are at or above the minimum rate.

After all clients are at or above the minimum data transmit rate, the radio reduces power by 1 dBm. As long as the radio continues to transmit at the minimum data rate or higher for all clients, the radio continues reducing power in 1 dBm increments until it returns to its normal power level.

A radio also can increase power, in 1 dBm increments, if more than the allowed percentage of packets received by the radio from a client are retransmissions. After a radio increases power, all clients must be at the minimum data rate or higher and the maximum retransmissions must be within the allowed percentile, before the radio begins reducing power again.

Examples — The following command increases the minimum data rate on radio 1, which is an 802.11b/g radio on the MAP access port on port 6, to 11 Mbps.

WX1200# set ap 6 radio 1 min-client-rate 11 success: change accepted.

See Also

„set radio-profileauto-tunepower-backoff- timer on page 284

„set radio-profileauto-tunepower-configon page 285