3Com 3CRWX440095A, 3CRWX120695A manual Priority

344CHAPTER 10: STP COMMANDS

set spantree	Changes the priority of a network port or ports for selection as part of
portvlanpri	the path to the STP root bridge, on one VLAN or all VLANs.
	Syntax — set spantree portvlanpri
	port-list priority value {all vlan vlan-id}
	„ port-list— List of ports. MSS changes the priority on the specified
	ports.
	„ priority value — Priority value. You can specify a value from 0
	(highest priority) through 255 (lowest priority).
	„ all — Changes the priority on all VLANs.
	„ vlan vlan-id— VLAN name or number. MSS changes the priority on
	only the specified VLAN.
	Defaults — The default STP priority for all network ports is 128.
	Access — Enabled.
	History —Introduced in MSS Version 3.0.
	Examples — The following command sets the priority of ports 3 and 4 to
	48 on VLAN mauve:
	WX1200# set spantree portvlanpri 3-4 priority 48 vlan mauve
	success: change accepted.
	See Also
	„ clear spantree portpri on page 321
	„ clear spantree portvlanpri on page 322
	„ display spantree on page 324
	„ set spantree portpri on page 342
set spantree	Changes the STP root bridge priority of a wireless LAN switch on one or
priority	all of its VLANs.
	Syntax — set spantree priority value {all vlan vlan-id}
	„ priority value — Priority value. You can specify a value from 0
	through 65,535. The bridge with the lowest priority value is elected to
	be the root bridge for the spanning tree.