3Com 3CRWX440095A, 3CRWX120695A manual Fwddelay, „ display spantree backbonefast on

338CHAPTER 10: STP COMMANDS

	See Also
	„ display spantree backbonefast on page 326
set spantree	Changes the period of time after a topology change that a WX switch
fwddelay	which is not the root bridge waits to begin forwarding Layer 2 traffic on
	one or all of its configured VLANs. (The root bridge always forwards
	traffic.)
	Syntax — set spantree fwddelay delay {all vlan vlan-id}
	„ delay — Delay value. You can specify from 4 through 30 seconds.
	„ all — Changes the forwarding delay on all VLANs.
	„ vlan vlan-id— VLAN name or number. MSS changes the
	forwarding delay on only the specified VLAN.
	Defaults — The default forwarding delay is 15 seconds.
	Access — Enabled.
	History —Introduced in MSS Version 3.0.
	Examples — The following command changes the forwarding delay on
	VLAN pink to 20 seconds:
	WX4400# set spantree fwddelay 20 vlan pink
	success: change accepted.

See Also

„display spantree on page 324

set spantree hello Changes the interval between STP hello messages sent by a wireless LAN switch when operating as the root bridge, on one or all of its configured VLANs.

Syntax — set spantree hello interval {all vlan vlan-id}

„interval — Interval value. You can specify from 1 through 10 seconds.

„all — Changes the interval on all VLANs.