3Com 3CRWX120695A, 3CRWX440095A manual Set ap dap, Upgrade-firmware

set {ap dap} upgrade-firmware 279

	Examples — The following command configures the transmit power on
	the 802.11a radio on the MAP access point connected to port 5:
	WX1200# set ap 5 radio 1 tx-power 10
	success: change accepted.
	The following command configures the channel and transmit power on
	the 802.11b/g radio on the MAP access point connected to port 1:
	WX1200# set ap 1 radio 1 channel 1 tx-power 10
	success: change accepted.
	See Also
	„ “display {ap dap} config” on page 237
	„ set {ap dap} radio channel on page 273
set {ap dap}	Disables or reenables automatic upgrade of an MAP access point’s boot
upgrade-firmware	firmware.
	Syntax — set {ap port-list dap dap-num}
	upgrade-firmware {enable disable}
	„ ap port-list— List of ports connected to the MAP access point(s) on
	which to allow automatic firmware upgrades.
	„ dap dap-num— Number of a Distributed MAP on which to allow
	automatic firmware upgrades.
	„ enable — Enables automatic firmware upgrades.
	„ disable — Disables automatic firmware upgrades.
	Defaults — Automatic firmware upgrades of MAP access points are
	enabled by default.
	Access — Enabled.
	History —Introduced in MSS Version 3.0.
	Usage — When the feature is enabled on an WX port, an MAP access
	point connected to that port upgrades its boot firmware to the latest
	version stored on the WX switch while booting.