3Com 3CRWX440095A, 3CRWX120695A manual Syntax display ap status port-listall radio 1

display dap status [dap-num[radio {1 2}]]

246CHAPTER 9: MANAGED ACCESS POINT COMMANDS

Table 48 Output for display ap group (continued)

Field	Description
Status	Association status of the MAP access point:
	„ Accepting — The MAP access point is accepting new
	associations.
	„ Refusing — The MAP access point is refusing new
	associations.
Refused	Number of association requests refused by the MAP access
	point due to load balancing. MSS resets this counter to 0
	when the WX switch is restarted, MSS is reloaded, or the
	access point is removed from the group.

See Also

„“set {ap dap} group” on page 267

display {ap dap} Displays MAP access point and radio status information. status

Syntax — display ap status [port-listall [radio {1 2}]]

Syntax —

„port-list— List of ports connected to the MAP access point(s) for which to display status.

„dap-num— Number of a Distributed MAP for which to display status.

„all — Shows status information for all directly attached MAP access points and all Distributed MAP access points configured on the switch.

„radio 1 — Shows status information for radio 1.

„radio 2 — Shows status information for radio 2. (This option does not apply to single-radio models.)

Defaults — None.

Access — Enabled.

History —Introduced in MSS Version 3.0. True base MAC addresses of radios are displayed in MSS Version 3.2. Previously, the base MAC address displayed for a radio was the true base MAC address plus 2. Note that a radio’s base MAC address is also used as the BSSID of the first SSID configured on the radio.