9

MANAGED ACCESS POINT

 

 

COMMANDS

Use MAP access point commands to configure and manage MAP access points. Be sure to do the following before using the commands:

„Define the country-specific IEEE 802.11 regulations on the WX switch. (See set system countrycode on page 51.)

„Install the MAP access point and connect it to a port on the WX switch.

„Configure a MAP access port (for a directly connected MAP) or a Distributed MAP. (See set port type ap on page 83 and set dap on page 73.)

CAUTION: Changing the system country code after MAP configuration disables MAP access points and deletes their configuration. If you change the country code on a WX switch, you must reconfigure all MAP access points.

MAP Access Point This chapter presents MAP access point commands alphabetically. Use

Commands by Table 43 to locate commands in this chapter based on their use.

Usage

Table 43 Map Access Point Commands by Usage

Type

Command

 

 

External Antenna

set {ap dap} radio antennatype on page 269

 

 

Radio Profile

set {ap dap} radio radio-profileon page 277

Assignment

 

set radio-profile mode on page 291

 

 

 

 

clear radio-profileon page 235

 

 

 

set radio-profileservice-profileon page 296

 

 

 

display radio-profileon page 257

 

 

SSID Assignment

set service-profilessid-nameon page 311

 

 

Page 231
Image 231
3Com 3CRWX120695A, 3CRWX440095A manual Commands