RAD Data comm Configuring IPmux-11 Units, Configuring the IP Parameters, Configuration Summary

Chapter 5 Configuring IPmux-11 for a Typical ApplicationInstallation and Operation Manual

Table 5-1. Configuration Summary

Device	E1 Parameters		IP Parameters	Bundle	Bundle Connection
				Parameters
IPmux-11 (A)	•	Transmit clock source:	Host IP address:	Bundle 1	Bundle 1 of IPmux-11 (B)
		adaptive	192.168.10.2	Timeslots in
	•	Line type: Framed G.704		bundle: 1–10
		CRC-4 enabled
	•	CAS: disabled
IPmux-11 (B)	•	Transmit clock source:	Host IP address:	Bundle 1	Bundle 1 of IPmux-11 (A)
		Loopback	192.168.10.1	Timeslots in
	•	Line type: Framed G.704		bundle: 1–10
		CRC-4 enabled
	•	CAS: disabled

5.2 Configuring IPmux-11 Units

This section explains how to configure IPmux-11 units. The configuration procedure is similar for both units, except for defining different host IP addresses, different clocking modes and different destination IP address for the bundle connection. Refer to Chapter 3 for explanation of how to select management options and save the changes.

Configuring the IP Parameters

To configure the host IP parameters:

•Display the Host IP menu (Configuration > System > Host IP), and configure the IP address and mask of the host:

1.Disable the DHCP mechanism

2.Save the changes

3.Set the IPmux-11 (A) host IP address – 192.168.10.2

4.Set the IPmux-11 (B) host IP address – 192.168.10.1

5.Save the changes.

Configuration>System>Host IP
1.	IP address	... (192.168.10.2)
2.	IP mask	... (255.255.255.0)
3.	Default gateway	... (0.0.0.0)
4.	DHCP	(Disable)
5.	DHCP Status	>

>
Please select item <1 to 5>	1 Mngr/s
ESC-prev.menu; !-main menu; &-exit

Figure 5-2. Configuring Host IP Parameters for IPmux-11 (A)

5-2 Configuring IPmux-11 Units IPmux-11 Ver. 2.00