RAD Data comm operation manual Application, Guidelines for Configuring IPmux-11 Units

Chapter 5

Configuring IPmux-11 for a Typical Application

This chapter provides detailed instructions for setting up a typical application using two IPmux-11 units.

5.1 Overview

Application

The section provides detailed instructions for configuring two IPmux-11 units operating opposite each other (see Figure 5-1).

Figure 5-1. Two IPmux-11 Units Operating Opposite Each Other

Guidelines for Configuring IPmux-11 Units

There are four basic configuration steps (described below) that need to be followed when deploying any IPmux unit.

1.IP Configuration – Setting the device host IP address and the manager IP address.

2.Physical layer configuration – Setting the TDM parameters (line type, clocking, etc.) according to the application requirements and topology.

3.Creating bundles – Allocating timeslots to bundles

4.Connecting bundles – Directing the bundles defined above to remote IPmux unit.

IPmux-11 Ver. 2.00 Overview 5-1